Temperature Transducers
Ideal untuk mendeteksi kebocoran air di area yang sulit dilihat, seperti di bawah lantai yang ditinggikan dan langit-langit palsu. Sensor Locate Rope Water akan memberi Anda lokasi kebocoran air secara tepat sehingga Anda dapat merespons secara efisien untuk melindungi sumber daya perusahaan Anda dari kerusakan air.
Sensor ini telah dirakit lengkap dan mencakup bagian tali yaitu kabel penginderaan air, kabel non-penginderaan (dari tali ke modul penginderaan) dan modul penginderaan utama. Kabel penginderaan dapat dipesan di muka mulai dari minimum 10 kaki hingga panjang lari khusus (dalam kelipatan 10 kaki) hingga 160 kaki. Kabel non-sensor memiliki panjang standar 20 kaki.
Lokasi spesifik air di sepanjang tali dapat digunakan untuk memicu peringatan seperti email, SMS, panggilan telepon, dan jebakan SNMP. Sensor memiliki SNMP OID sendiri sehingga dapat dipantau melalui jaringan menggunakan Sistem Manajemen Jaringan apa pun.
Setiap sensor Air Locate Rope dilengkapi dengan kabel sensor 5 kaki yang menghubungkan modul penginderaan utama ke port sensor RJ-45 unit dasar pemantauan jarak jauh AKCP, atau Anda dapat menggunakan kabel LAN CAT5/6 Anda sendiri. Kabel ini dapat dipanjangkan hingga 100 kaki atau 30 meter.
Specifications
| Measurement Type |
Wet or Dry
Closest location detection |
| Measurement Rate |
Multiple readings every second |
| |
Able to detect the presence of water at specific location |
| Indication |
LED for Status |
| Operating Temperature |
-20 °C~60 °C
4 °F~140 °F |
| Pull Force Limit |
Not to exceed 50 lb |
| Bend Radius |
2 in. (50 mm) minimum |
| Pressure |
Loads greater than 20 lb (9 kg) per linear inch at 20°C (68°F) may immediately trigger an alarm |
| |
|
| Interface |
|
| Communications Cable |
RJ-45 jack to sensor using UTP Cat 5 wire |
| Communications Cable Max. length |
The Locate Rope Water Sensor can be extended from the RJ-45
Intelligent Sensor ports on the base units up to 100 feet, or 30 meters
using standard CAT5/6 LAN cable.
Comes fully assembled and includes the rope portion that is the water
sensing cable, the non-sensing area cable (from the rope to the sensing
module) and the main sensing module
Sensing rope cable can be pre-ordered from a 10 feet minimum to any
custom run length (in multiples of 10 feet) of up to 160 feet or 50
meters.
Non-sensing cable comes in a standard 20 feet run length.
|
| Power Source |
Powered by the controller unit. No additional power needed |
| |
Full autosense including disconnect alarm |
| Power Consumption |
Typical 125 mWatt, 25 mA |
| Dimensions |
56 x 55 x 33.3 mm |
| Mounting |
DIN rail mounting
Screw mounting |
| Important Note |
AKCP does not recommend the locateWater Sensor to be placed on a conductive surface. |
| Sensor count |
1 |